Non Dismantle Test
The detector is using advanced technology from Germany, it can collect and analyze signals under non-dismantle automotive electrical parts, Testing results are showed by LED indicator and beeper. Easy to test if there is faults of the automotive electronic parts.
Testing Range
-Coil(traditional coil, double spark coil, dingle spark coil)
-Electric generator, inside fan motor, combination valve(heating, water cooling)
-Emission controling valve, fuel injector, spark plug, hall sensor, electric relay
Instructions
1.The car to be tested should park at an area with good air condition, can not suck into exhaust emission from engine.
2.The car to be tested should be far away from smoke and fire source;The gasoline engine and chargeable battery is possible to occur explosive air, so it is very necessary to prepare fire extinguish gears accordingly.
3.During test process, it is necessary to avoid the moving parts and heat source to protect tester and testing equipment.
4.To be far away from the cooling fan of engine
5.Do not put other equipment on the battery which is possible to make the battery inside to be Short, which may cause hurt or
damage of tester and equipment.
6.Do to turn off the ignition switch before connecting or remove electrical parts.
7.Do not leave the car during the test
8.Please confirm the gear position of the car : automatic is at P; manual is at blank; Do push tight of manual brake ; put blocks before the driving tires
9.Please read relative warnings from car manufacturer,pay attention to the important warning information.
